1 x Oil Seal (Öldichtung) Key benefits Prevents oil leaks and retains lubrication at shaft interfaces to protect bearings, gears and housings. Simple, cost-effective replacement that restores sealing performance and helps avoid equipment damage and downtime. Compact, single-piece supply—ideal for targeted repairs or maintenance tasks. What this product does Seals the gap between rotating or stationary shafts and housings to keep lubricant in and contaminants out. Reduces wear and extends the service life of the surrounding components by maintaining proper lubrication. Important attributes (what to check) Quantity: 1 oil seal included. Function: primary sealing element for oil-lubricated shafts. Compatibility: designed to replace a single oil seal—confirm fit by matching the original part’s inner diameter, outer diameter, thickness and design type before ordering. Size and fit: sold as one unit; verify dimensions against your existing seal or OEM part number to ensure proper installation. Material and performance: manufactured to perform as an oil seal—confirm the specific material and temperature/pressure ratings against your application requirements before installation. Typical use scenarios Engine maintenance: replace a worn crankshaft or camshaft oil seal during routine engine service to stop oil seepage. Gearbox or transmission repair: install as part of a gearbox rebuild to restore effective sealing around shafts and prevent lubricant loss. Hydraulic and pump equipment service: use when sealing rotating pump shafts or similar components where oil retention is required. Practical notes Always compare the old seal’s dimensions and profile with the replacement to ensure correct fit and sealing lip orientation. Clean mating surfaces and inspect shafts for wear or grooves before installing the new seal to ensure long service life. If application conditions require specific materials (e.g., high temperature, chemical resistance), confirm material compatibility prior to purchase. Ordering guidance This listing is for a single oil seal (Öldichtung). Confirm the required size and specifications from your equipment manual or the existing part before ordering to ensure compatibility.