Product description A compact 0–10 V signal conversion module that accepts a modulating 0–10 V input and provides an adjustable 0–10 V analog output for PLCs, MCUs and industrial controllers. Key benefits Simple integration: provides a direct 0–10 V analog output that matches standard analog inputs on PLCs, MCU ADC circuits and many industrial controllers. Predictable performance: maximum output current ≈ 10 mA, suitable for driving standard high-impedance analog inputs or reference inputs. Safe supply limits: clear supply requirements reduce risk of miswiring and damage when installed correctly. Main functions and specifications Input: designed for a modulating 0–10 V signal. Output: adjustable analog voltage in the 0–10 V range. Power supply requirements: the supply voltage must be at least 2 V higher than the desired analog output voltage (i.e., supply ≥ output + 2 V). Do not exceed 30 V for the power supply. Maximum output current: approximately 10 mA (suitable for high‑impedance inputs; not intended to drive low‑impedance loads directly). Compatibility: specifically suited for standard 0–10 V interfaces used by most PLCs, microcontroller analog inputs and many industrial controllers. Installation and usage notes Ensure the power supply voltage always remains at least 2 V above the highest expected analog output, and never above 30 V. Observe the ~10 mA output current limit; use a buffer amplifier if a larger output current or lower load impedance is required. Confirm wiring polarity and signal reference (ground) to avoid signal errors. Typical applications PLC input simulation and testing: emulate sensor or process signals (0–10 V) for commissioning, calibration or diagnostics of PLC analog inputs. MCU and lab bench signal source: provide a stable, adjustable 0–10 V reference for ADC testing, algorithm development and hardware-in-the-loop experiments. Industrial control integration: supply a controlled 0–10 V control or reference signal to industrial controllers, valve positioners or other 0–10 V control devices that accept low-current inputs. Why choose this module Direct 0–10 V compatibility with standard automation and control equipment. Clear supply and output limits make it straightforward to design into systems without guesswork. Low output current and high-impedance compatibility fit typical analog input requirements; use external buffering for heavier loads. Specifications summary Input signal range: 0–10 V Output range: 0–10 V adjustable Power supply constraint: supply ≥ output + 2 V; supply ≤ 30 V Max output current: approx. 10 mA Suitable for: PLCs, MCUs and industrial controller 0–10 V interfaces Note: Follow the stated supply and output current limits when integrating this module. Use an appropriate buffer or driver if your application requires higher output current or lower load impedance.