Carbon Fiber Round Square Steel Tube Towel Rack Timer Thermostat Switch Thermostat Working principle: When the product is connected to the power supply network, the LEDs are not lit (standby mode). The product is included in the power supply network, without a choice of operation mode (off-the product does not heat up, the power is 0%) The product is turned on/off by pressing and holding the button for 3 seconds. After that, the 1st LED will light up (mode I) -the product heats up at 60% power. To change the mode of operation (power), you must press the button without holding. Each subsequent Press changes the heating mode: I-II-III-OFF. Mode II (1th and 2th LEDs)-Heat up at 80% power Mode III (three LEDs on)-the product is heated at 100% power Press the button to select the required working time of the product. Each button press will set the shutdown timer to the desired time frame. According to the selected time, the corresponding LED will light up: Shutdown After 2 hours-LED is on, Shutdown After 4 hours-LED is on, Shutdown after 6 hours-the LED is on. If none of the diodes is lit, the product works in constant mode. The product is turned off by pressing and holding the button for 3 seconds. When the current is out and on again, the work of the product is transferred In standby mode (the product does not heat up, the power is 0%, the timer is not set, LEDs do not burn). Appearance face Diode backlight (green) Voltage-230 in 10% Adjustable power up to 150 W Regulator housing-Chrome (mirror) 4 with a fit on a round tube 25mm and a profile tube 30x30 Fastening the regulator body to the towel rail pipe-6 latches around the perimeter. Mount the board to the body-2nd self-tapping screws. Regulator complies with the requirements of the regulation on Emes (electromagnetic compatibility) Overall dimensions of the regulator body: height (c) not more than 23mm x width (W) not more than 20mm x length (e) not more than 61mm Buttons Appointment: Timer button (2 H, 4 H and 6 h) .. Each consecutive press of the Button sets the duration of the heated towel rail (2 H, 4 h, 6 h, off). Depending on the chosen duration of work, the corresponding LED is lit. If none of the diodes is lit, the timer is disabled. Button-on/off of the towel dryer, selection of the heating mode (I, II, III). Terms of Reference Two-button six-light LED controller (green) Square Technical Description: 1-Product Type: square tube e.com 30mm Size with 2 holes (recommended): 62,8*20,6mm 3-Mount Screw (Recommended): ST3 * 5mm 4-Color (Type): Silver/Black/White Mark 5-"*" is the key size. Round technical description: 1-Product Type: round pipe diameter 32mm. Size with 2 holes (recommended): 62,8*20,6mm 3-Mount Screw (Recommended): ST3 * 5mm 4-Color (Type): Silver/Black/White 5-sign "*" is the key size _x000D_ _x000D_