Product: Metal Lathes accessory (shrink sleeve) Key benefits Protects and organizes wiring and components on metal lathes by providing a secure, heat‑shrink fit. Rated for electrical applications up to 600 V (bracket voltage), helping maintain safe insulation under load. Wide operating temperature range (55°C to +125°C) for reliability in cold start conditions and elevated machine temperatures. 50% shrinkage ratio activated at 70°C so the sleeve conforms tightly to irregular shapes and connectors. Supplied in a 1 m length for flexible placement and easy cutting to size during maintenance or installation. Important attributes Function: Heat‑shrink sleeve designed for use with metal lathes to provide insulation, strain relief, and protection for wiring and small components. Compatibility: Suitable where a 1 m heat‑shrink sleeve with 50% shrinkage and a 600 V bracket voltage rating is required. Size: Total length 1 M; shrinkage ratio 50% (final diameter depends on initial diameter). Performance: Activates at 70°C; rated to operate safely from 55°C up to +125°C. Electrical rating: Bracket voltage 600V, suitable for many machine tool electrical applications. Practical use scenarios Machine wiring protection: Use the sleeve to insulate and bundle control wiring on a lathe, preventing abrasion against metal surfaces while maintaining a 600 V electrical rating. Component and modification: Cut to the required length, heat to 70°C to shrink, and secure damaged or exposed cable terminations during maintenance without replacing entire harnesses. Environmental protection: Apply to connectors and small sensors on lathes operating in environments where temperatures may vary between 55°C and +125°C. Installation notes (practical) Measure and cut the sleeve to length before shrinking. Expect approximately 50% reduction in diameter once heated to the shrinkage temperature of 70°C. Use a controlled heat source that reaches the activation temperature to ensure uniform shrinking without overheating adjacent components. Verify electrical and mechanical clearances after installation to confirm the sleeve meets the required 600 V bracket voltage application. Specifications summary Product type: Metal Lathes accessory (heat‑shrink sleeve) Length: 1 M Shrinkage: 50% Shrinkage temperature: 70°C Operating temperature range: 55°C to +125°C Bracket voltage: 600V