High quality PICKIT3 Programmer USB (12 Mbps interface to host PC), real-time execution, MPLAB IDE compatible (free copy included) The MPLAB PICkit 3 enables debugging and programming of PIC and dsPIC Flash microcontrollers at an affordable price point using the MPLAB Integrated Development Environment (IDE). The MPLAB PICkit 3 connects to a PC via USB and interfaces with the target device using an RJ-11 debug connector (compatible with MPLAB ICD2, MPLAB ICD3, and MPLAB REAL ICE). Supports operating voltages from 2.0 V to 6.0 V Diagnostic LEDs (power, busy, error) Read/write program and data memory of microcontroller Erase and verify program memory Freeze peripherals at breakpoint Program up to 512 KB flash memory with Programmer-to-Go functionality Instructions for use: For 28-pin and 40-pin microcontrollers: align left; use shorting cap at position A. For 8-pin, 14-pin, 18-pin, and 20-pin microcontrollers: align left; use shorting cap at position B. For ICD2, ICD3, and PICkit 3 programming: use 6-pin header or 6-pin cable. Supported microcontrollers: - PIC16/18XX 40-pin series devices (except PIC16F59) - PIC16/18XX 28-pin series devices (except PIC16F57) - PIC16/18XX 18-pin series devices - PIC 8-pin / 14-pin / 20-pin family devices (except PIC10FXX) Color: Red Material: Plastic Dimensions: 14.5 x 7 x 4 cm Package includes: 1 x PICkit 3 Programmer 1 x USB Cable 1 x 6-Pin Programming Cable 1 x Universal Programmer Socket Note: Color may vary slightly due to monitor settings and lighting conditions. Dimensions are subject to a tolerance of ±1–3 cm.