This long-range communicator based on Wi-Fi HaLow can replace Ethernet cables in certain scenarios. IEEE 802.11ah protocol, HT-HD01 operates in the unlicensed SUB-1G frequency band (902-928 MHz). It offers four bandwidth modes (1/2/4/8 MHz), with a maximum transmit power of 27±1 dBm and data rates of up to 32.5 Mbps@8M. A long-range communicator based on Wi-Fi HaLow, the communication range is 1-2 km. It can be used to extend the coverage of traditional networks through bridging, to set up LAN, or to as an IoT protocol. Pair two devices for use, or work with the HaLow gateway. HaLow Dongle is a plug-and- bridge designed to significantly extend the transmission range of traditional networks, offering lower power consumption and improved penetration capabilities. You can think of it as a type of ultra-long-range Wi-Fi or Ethernet cable, and maintaining high transmission speeds even at extended distances. You can connect your device to the Dongle through three methods: USB Type C, Ethernet, and 2.4GHz WiFi. Long transmission range.It can be seamlessly connected to traditional networks.Large capacity allows access to a large number of devices simultaneously.Low power consumption design with high penetration. Specification: MCU: MT7628 Wi-Fi: IEEE 802.11 b/g Wi-Fi HaLow: IEEE 802.11 ah Frequency: 902-928MHz Max. TX power: 27±1dBm(V2) Bandwidth: 1/2/4/8 MHz Max Data Rate: 32.5 Mbps @ 8 MHz ANT Interface: SMA female socket Ethernet: RJ45(10/100M),USB-C Operating Temperature: -20 - +70℃ Operating Humidity: 10%-90%( no-condensing) Power: USB-C, 5V Consumption: 300mA(Typical) Ingress Protection: Without waterproof features Color: Black Material: Aluminum Plastic Package Contents: 1 * AP Mode Wireless Network Bridge 1 * STAMode Wireless Network Bridge 1 set * accessories (accessory colors are random, don't accept the specified color) Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.