1. Automatically charges the battery. 2. The rectifier and brake circuit use an integrated module, offering improved heat dissipation and reliability. 3. Fully sealed and waterproof design with IP67 protection rating. Suitable for long-term use in wet environments. Note: Ensure the wind turbine generator’s output voltage matches the battery’s rated voltage. Connect wires in the following order: first connect the battery’s positive (red) and negative (black) terminals to the controller, then connect the wind turbine’s three-phase output wires (green) to the controller’s three-phase input terminals. Incorrect wiring—such as reversed polarity or misconnection—may cause system malfunction or permanent damage to the controller. Wiring Instructions: 1. Connect the battery’s positive and negative terminals to the controller’s red (+) and black (–) battery terminals. 2. Connect the wind turbine’s three-phase output wires to the controller’s three-phase input terminals (green wires). Specifications: 1. Maximum input AC voltage: 35V AC 2. Output voltage: 12V or 24V 3. Battery charging cutoff voltage: 14.5V ±0.3V (12V system) or 29V ±0.3V (24V system) 4. Maximum charging current: 15A (for 12V), 10A (for 24V) 5. Wind generator speed-limit voltage: 14.5V ±0.3V (12V system) or 29V ±0.3V (24V system) 6. Protection rating: IP67 7. Static power consumption: 0.008A 8. Rated power handling: 800W 9. Maximum wind speed rating: 12 m/s 10. Operating temperature range: –35°C to +65°C 11. Input wiring configuration: Three-wire system 12. Control compatibility: Supports both 12V and 24V systems 13. Mounting method: Bolted installation 14. Never reverse the battery polarity—doing so may destroy the controller. Application: Wind turbine charge controller Color: Blue Material: Aluminum alloy Package Includes: 1 × Wind Turbine Charge Controller Note: Color appearance may vary slightly due to lighting conditions and screen settings. Measurement tolerance: ±1–3 cm.