Automatic Melting Strapping Tool for Portable, Force Packaging Key benefits Fully automatic weld and cut: Insert the strap, press the tension button, then press the welding switch. The tool automatically tightens, melts the strap joint, and trims the excess for a secure finish. Fast operation: Large tightening force and quick cycle time let one operator bundle a pack of timber in under one minute, reducing labor and turnaround time. Easy to use: degree of automation makes the tool suitable for nonprofessionals and experienced users alike. Simple controls deliver consistent results with minimal training. Lightweight and portable: Tool plus battery weighs 6.6 lbs, allowing singlehand handling and use in tight or elevated work areas. Adjustable tension for different loads: Pulling force can be set from 900 to 3200 N using the manual adjustment knob to match load and strap type. Specifications and compatibility Strap type: Compatible with PP and PE belts Strap width: 11 to 16 mm (0.43 to 0.63 inch) Strap thickness: 0.4 to 1.2 mm (0.01 to 0.04 inch) Tension range: 900 to 3200 N, adjustable Battery: 4000 mAh rechargeable lithium battery Battery performance: Full charge in 90 minutes; approximately 2 hours of continuous operation; packs about 250 to 350 straps per charge Battery lifespan: Rated for approximately 2000 recharge cycles Weight: Tool with battery 6.6 lbs How it solves common packaging problems Replaces manual strapping methods that are slow, inconsistent, or physically demanding. Delivers repeatable, strong joints suitable for heavyduty loads without a separate sealing tool. Reduces downtime with a fast charge cycle and a number of strap applications per charge. Typical applications Timber and lumber yards: Rapidly bundle planks and packs for transport or storage; a single operator can complete straps in under a minute. Warehousing and logistics: Secure pallet loads of cartons, bags, or boxed goods where a portable, battery powered solution is needed. Construction and metalwork: Strap pipes, rebar bundles, or prefabricated components on site where corded equipment is impractical. What to expect in use Insert strap and use the tension button to reach the desired tightness. Use the welding switch to initiate automatic melt welding and cutting. Adjust tension with the knob to match strap width, thickness, and load. The unit is designed for on site portability and frequent use. The lightweight design reduces operator fatigue while maintaining sufficient tightening force for heavy packages. Ordering notes Confirm strap material, width, and thickness match the listed compatibility before use. Follow standard safe handling and battery charging practices supplied with the unit. This tool is intended for efficient, portable strapping where speed, repeatability, and ease of use are priorities.