Rear vision replacement components for Air 2 rear visual system Restore rear visual sensing and positioning on Air 2 models with these directfit replacement components. Designed for use, they help recover functionality after impact or wear without replacing the entire rear module. Key benefits Restores rear visual detection and positioning so the aircraft can resume safer operation. Cost effective alternative to full module replacement. Precise fit and alignment with original mounting points to simplify installation. Lightweight design preserves flight balance and handling. Durable construction suitable for repeated installation and routine maintenance. What this part does Replaces damaged or nonfunctional rear visual components used by the Air 2 rear sensing system. Reestablishes the physical and optical alignment required for accurate visual positioning during flight and landing. Interfaces with the existing rear housing and connector layout for a straightforward swap. Compatibility and fit Compatible with Air 2 series aircraft that use the rear visual sensing module. Engineered to match the original form factor and attachment points for plug and play replacement. Typical use scenarios after a hard landing or minor collision that damaged the rear visual assembly. Routine maintenance for commercial inspection or photography drones to ensure reliable rear sensing before a project. Parts replacement in a to a customer aircraft to operational condition quickly. What to expect Component delivered ready for installation; designed to integrate with the existing rear housing and connectors. Recommended inspection of connectors and surrounding mounts during replacement to ensure full system restoration. This part is intended for technicians and operators familiar with drone repairs. If unsure about installation, consult a qualified service.