Replacement hub seal compatible with AR26480 and CHStet04690 Fits John Deere models 6200, 6300, 6400, 6500, 7200, 7400, 7500, 7600, and 7700 Product purpose and function Seals the hub and wheel end to retain lubricant and keep contaminants out. Replaces worn or damaged seals to restore proper hub lubrication and prevent leaks. Directfit replacement for the listed part numbers and compatible tractor models. Key benefits Stops oil and grease loss that can lead to premature bearing wear. Keeps dirt, water, and debris from entering the hub, reducing the risk of corrosion and component failure. Restores correct sealing dimensions and fit for reliable performance after or maintenance. Simple swapin replacement that helps the hub assembly to normal operation. Important attributes Compatibility: Replacement for AR26480 and CHStet04690, fits specified tractor model list above. Function: Hub/wheel end sealing to maintain lubrication and exclude contaminants. Fit and sizing: Manufactured to match original fit dimensions for direct replacement of the listed part numbers. Durability and performance: Designed to maintain an effective seal under normal agricultural operating conditions. Typical use scenarios a leaking front or rear hub seal during routine maintenance to stop visible grease loss and protect wheel bearings. Install as part of a hub rebuild after bearing replacement to ensure the assembly is sealed and lubricated correctly. Fit during seasonal service to prevent ingress of dirt and moisture before heavy field work. Notes for installers Intended as a direct replacement for the specified part numbers and tractor models. Verify part number and model compatibility before installation. Use standard hub service procedures and recommended lubricants when reassembling the hub. This replacement hub seal is intended to restore sealing function and protect hub components on compatible tractor models when the original seal is worn or damaged.