Generic Single Channel Passive Video Balun UTP Video Transceiver RJ45 to Coax Pack of 2 Product overview A pair of single channel passive video baluns designed to transmit composite video signals between coaxial camera connections and UTP cabling using RJ45 connectors. The passive transceiver design requires no external power and provides a simple way to adapt or extend analog video links over common network cable. Key benefits Simple conversion: Converts coaxial video to and from UTP with an RJ45 interface, allowing use of existing network cable for a single analog camera channel. No power required: Passive design eliminates the need for power supplies or additional wiring at the camera or recording device. Easy installation: Compact units plug directly into camera and recorder coax ports and into RJ45 terminated UTP runs for quick setup. Cost effective and flexible: Use the included pair to long coax runs with Category UTP cable or to integrate analog cameras into structured cabling systems. Reliable signal handling: Designed for single channel video transmission with consistent performance when paired and wired correctly. Key attributes Function: Passive single channel video balun and transceiver for conversion between RJ45 terminated UTP and coaxial video. Compatibility: Intended for standard analog composite CCTV cameras and recording equipment that use coaxial video connections and RJ45 terminated UTP cabling. Connectors: Coaxial side for camera and recorder connections, RJ45 side for UTP cable termination. Pack contents: Two matching passive baluns suitable for one complete channel link. Form factor: Compact, lightweight units for installation in tight spaces or equipment enclosures. Typical applications CCTV retrofit: long coax runs with existing UTP cable to simplify wiring during renovations or to extend camera reach. Mixed cabling environments: Connect an analog camera to a DVR located where only RJ45 UTP infrastructure is available. Small installations: Home, office, or retail camera setups where a single analog channel needs conversion or extension without adding power supplies. Practical notes Use one unit at the camera end and one at the recorder end for each video channel. For results, use quality UTP cable and proper RJ45 terminations. These are passive devices intended for single channel analog video; verify camera and recorder compatibility before installation.