GLXFLORP Flow Switch Assembly Overview This flow switch assembly is a directfit flow sensor designed for salt chlorination systems. It detects water flow and signals the control unit to allow cell operation, helping prevent damage from dry running or insufficient circulation. The unit includes a 15 FT cable for flexible positioning and straightforward connection to compatible controllers. Key benefits Restores proper flow detection: Replaces a failed or intermittent flow switch to the salt cell and chlorine generator to normal operation. Protects pool equipment: Prevents the chlorinator from running when flow is inadequate, reducing risk of cell damage or premature wear. Easy installation and placement: 15 FT cable length simplifies routing and lets you mount the sensor where it reads system flow without extra extension parts. Compatibility for straightforward replacement: Intended for use with Hayward Goldline Aquarite and Aqua Rite style salt systems and compatible control modules. Reliable signal to controller: Provides consistent on off detection to help your chlorination system make correct operational decisions. Important attributes Function: Flow switch assembly for pool salt cell and chlorine generator flow sensing. Compatibility: Compatible with Hayward Goldline Aquarite and Aqua Rite salt chlorination systems and related control modules that use the same flow switch interface. Cable length: 15 FT cable for flexible installation and reach to control box. Form factor: Designed to match common replacement dimensions and mounting points for direct swap into existing systems. Performance: Intended to detect adequate water flow and provide a clear electrical signal to the chlorinator control unit. Use scenarios 1) Replacement after failure: Swap this assembly into a salt chlorinator when the system indicates no flow or the cell will not energize, restoring normal operation without rewiring the controller. 2) Maintenance upgrade: During routine pool equipment service, upgrade an aging or corroded flow switch to ensure continued reliable flow detection and reduce nuisance shutdowns. 3) System relocation or routing: Use the 15 FT cable to mount the sensor at an point in the plumbing when the control box is relocated or when plumbing layout prevents short cable routing. Notes Verify compatibility with your control module model before . This part is intended as a replacement flow switch assembly for systems that accept this form factor and connector arrangement.