DC Micro Hydro Generator Model: DC Micro Hydro Generator Compact microhydro generator that converts flowing water into DC power for lowpower electronic devices. Designed for easy installation and stable operation in applications where a small, reliable DC supply is needed from water flow. Key benefits Selfpowered supply for flowactivated electronics: provides DC12V output without external batteries or large power supplies, suitable for lowpower sensors and control circuits. Starts at very low water pressure: reliable startup at 0.05 MPa, so the unit works with modest flow and pressure conditions. Durable construction: stainless steel machinethread screws and iron shaft improve longevity while added bearings reduce wear on moving parts. Safe separation of water and electricity: water and electricity separation technology combined with a dual magnetic circuit coupling clutch reduces risk of direct contact between water and electrical components. Improved generation efficiency: enlarged vortex impeller and lowflowloss waterway design increase energy conversion while keeping noise and interference low. Features and specifications Output peak voltage: 12 V Output peak current: 220 mA at 12 V (peak) Line to line resistance: 10.5 plus or minus 0.5 ohm Insulation resistance: 10 megaohm (measured with DC100 megohmmeter) Outlet closed peak withstand pressure: 0.6 MPa Outlet opening peak withstand pressure: 1.2 MPa Starting water pressure: 0.05 MPa Inlet and outlet: four point external screw design, outer diameter approximately 20 mm Terminal: 2 pin Shaft material: iron Screws: stainless steel machine wire screws Mounting base: without mounting base Installation method: assembly Practical applications and scenarios Smart faucets: power touchless sensor modules and control electronics directly from incoming water flow, eliminating the need for batteries or external adapters. Gas water heaters and hot water controllers: supply lowpower control circuits or ignition electronics in systems where water flow is present. Small kitchen appliances and flowactivated devices: power small induction or control modules that require a stable 12 V DC input when water is running. Installation and compatibility notes Designed for assembly installation and connection via the provided 2 pin terminal. Both inlet and outlet use a four point external screw with an outer diameter of about 20 mm; verify plumbing fittings and adapters before installation. Intended for lowpower electronic loads that match the 12 V and up to 220 mA peak output characteristics. What makes this product stand out Low startup pressure and low flow loss waterway design make it effective in systems with limited water pressure. Water and electricity separation plus dual magnetic circuit coupling clutch provide a safer mechanical isolation approach. Enlarged vortex impeller and added bearings improve conversion efficiency and reduce mechanical wear for longer service life. Use the DC Micro Hydro Generator where a compact, flowdriven DC source is required for lowpower electronic components in faucets, heaters, and similar waterflow devices.