Size: 5 Channel 2PCS Overview Durable cable protector ramps designed to keep cables and hoses intact while reducing trip hazards in driveways, work sites, and busy pedestrian areas. Built from industrialgrade rubber for wear resistance and long service life. Key benefits Protects cables and hoses from vehicle and foot traffic, preventing pinching and crushing. load capacity supports up to 39,000 pounds, enabling driveover durability for most light and medium vehicles. visibility yellow and black with a retroreflective surface improves recognition in low light, helping to alert drivers and pedestrians. Quick to install and stays in place: presplit rear, ribbed nonslip base, and antislip texture prevent shifting and bulging. Modular design and dual channels allow multiple cords or hoses to run through a single protector while keeping driveway surfaces flat. Features Material: Industrialgrade rubber resistant to deformation and wear. Load rating: 39,000 pounds trafficready. Channels: Dual channels with internal dimensions 11/4 inches by 13/16 inches. Finish: Yellow and black color scheme with retroreflective surface for enhanced visibility. Installation: Presplit rear for easy insertion of cables and a ribbed base for traction on smooth floors. Package: Two pieces included. How it solves common problems Stops cable damage from vehicle tires and foot traffic by routing cords inside durable channels. Reduces trip hazards and visual confusion with a clear contrast design and reflective surface. Prevents cables from bulging or pinching in traffic zones by holding them flat and secure. Use scenarios Driveways and parking lots: run extension cords or temporary power cables across vehicle paths without damaging cables. Outdoor events and construction sites: protect power lines and hoses where frequent foot and vehicle traffic occurs. Residential and garden use: shield garden hoses or power cords from lawn equipment and offroad vehicles. What is included and compatibility Two ramp pieces per pack. Each piece offers dual cable channels sized 11/4 inches by 13/16 inches, suitable for most extension cords, power leads, and garden hoses. Modular speed bump system allows placement in series for longer runs and broader coverage. Installation notes Slide cables into the presplit opening from the rear, then position the ramp on the surface. Place on a flat surface for contact; ribbed base minimizes movement on smooth floors. Multiple pieces can be connected side by side to span wider areas or to create a continuous protected route. Choose these cable protector ramps when you need a rugged, visible, and easy to install solution for protecting cables and hoses under vehicle and pedestrian traffic.