5-Way Navigation Switch Module for Arduino and Raspberry Pi Up Down Left Right Center Tactile Joystick

Five-Way Tactile Switch Module, 24 x 20 mm. Key benefits: - Compact five-direction control in a single component for intuitive navigation and precise input. - Simple wiring and direct active-low outputs make it easy to integrate with microcontrollers and development boards. - Clear pinout and solder-through pins provide reliable mechanical and electrical connections for prototypes and finished products. What it does: - Provides directional switches for up, down, left, right, and center press functions. - Each direction connects its corresponding IO pin to ground when activated, producing a logic low signal. - When not pressed, the IO pin reads logic high, so configure the microcontroller IO as bidirectional input with pull-up to read consistent states. Key features and specifications: - Direction pins: F for up, B for down, L for left, R for right, M for center. - Ground pin: GND for common reference. - Wiring: Solder the pins to the PCB or wires, connect GND to the microcontroller ground using a Dupont cable or equivalent connector, and connect each direction pin to the corresponding IO pin. - Signal behavior: Pressing a direction shorts the corresponding IO pin to ground, yielding a low level; releasing returns the pin to a high level. - Size: 24 x 20 mm, suitable for compact control panels and handheld devices. - Mounting: Through-hole solder pins for secure attachment and easy replacement. Compatibility and usage: - Designed for use with microcontrollers and modules that accept active-low inputs and can be configured for bidirectional IO. - Compatible with standard Dupont wiring for quick prototyping and testing. Typical applications: - Menu navigation on handheld devices and user interfaces where compact multi-directional control is needed. - Robotics and remote controls for directional commands and mode selection. - DIY electronics, game controllers, and prototype boards for directional input and selection. Basic wiring summary: - Solder all pins securely. - Connect GND pin to the microcontroller ground. - Connect F, B, L, R, and M pins to the microcontroller IO pins you will use for up, down, left, right, and center inputs. - Configure each IO pin as a bidirectional input with pull-up so pressed reads 0 and released reads 1. This five-way tactile switch module delivers a compact, reliable way to add five-directional input to embedded projects and user interfaces.