DN25 Three-way Three-wire Electric Ball Valve, DC 24V, G3/4 Brass Electric Ball Valve, compatible with fan coil units and

Specifications: Model DN20, Three-wire two-control valve; Body material: Brass; Stem material: 304 Stainless Steel; Sealing material: Special Rubber; Actuator base material: Die-cast Aluminum; Actuator housing material: Flame-retardant ABS Engineering Plastic; Drive motor: Hysteresis Synchronous Motor; Driver operating voltage: DC24V; Power consumption: 7.5VA; Valve body pressure: 1.6MPa; Allowable pressure: 0.1Pa; Compatible media: Cold water, Hot water; Compatible media temperature: 2.95℃; Compatible ambient temperature: 0.60℃; Opening time: Approx. 10 seconds; Closing time: Approx. 5 seconds; Valve connection type: G3/4; Weight: Approx. 647g/22.8oz; Height: Approx. 13.3cm/5.2 inches; Dimensions: Approx. 7*6.3cm/2.8*2.5 inches; Diameter: Approx. 2.5cm/1.0 inch; Package list: 1. * Electric ball valve installation and commissioning: 1. Before installation, carefully read the instruction manual, disconnect the power, and have it installed by a professional. 2. The flow direction must be consistent with the arrow direction on the valve body. 3. The valve body must be located above the fan water tray to ensure that the dripping water falls into the water tray. The valve body and actuator must be installed vertically at an angle within 60°, with at least 30mm of clearance above. The building must provide sufficient space for maintenance and operation, and the valve must be installed in a maintenance area accessible to maintenance personnel. Two or more electric valves cannot be connected in parallel; if parallel connection is necessary, independent relays must be used.