Teeth Resin Tooth Repair Dental Cement for Cavity Filling, Light Curing Composite Resin Restoration Solution, 2.5g Shade A1 A2 A3

Specification:Type: light curing composite resinShade: A1 A2 A3Net weight: 2.5gColor: as picture showQuantity: 1pcsFeatures:1. Low polymerization shrinkage.2. High strength and polishability.3. Similar modulus of elasticity to dentine.4. Radioopaque and fluoride releasing, with optimal polishability and high shade stability.5. Easy to mold.6. Easy to adhere to brackets for orthodontics.7. Simple and convenient to use.8. Used for all types of cavity preparations. Usage:1. Prepare cavities according to conventional requirements, remove decayed tissue, and clean the cavities.2. Apply dental composite resin pre-treatment agent (etchant) to the tooth surface to be bonded, rinse and blow dry the bonding surface.3. Apply a uniform, thin layer of dental composite resin pre-treatment agent (adhesive) on the bonding surface, and illuminate it with a dental light curing lamp for 20 seconds.4. After filling and carving with an appropriate amount of composite resin, the light intensity should not be less than 400mW/cm; irradiate the light source for 20 seconds to solidify. Curing depth 1.5mm. If the filling depth is large, the irradiation time can be appropriately extended or layered solidification filling can be carried out.5. Carry out trimming and polishing, and inspect with dental bite paper before trimming. It is recommended to use rubber polishing wheels and ultra-fine abrasive polishing strips.6. Recommended pulp protection and cushioning materials: calcium hydroxide (light cured or chemically cured) or other non-oily cushioning materials. Do not use materials containing eugenol directly as a base.Scope of application: Non-occlusal cavity filling repair.Attention: Close the lid immediately after use to avoid exposure to light.Contraindications: For pulpitis, use with caution. When penetrating the pulp or near the pulp chamber, pulp capping and pulp protection surgery are necessary before filling with resin. Other pulp diseases should be treated before filling.Storage conditions: Store at room temperature and avoid direct sunlight.