Features: Super long endurance Forsted cover make the light softly and no glare Intelligen energy-saving Warm and cold optional About the color "Warm + RGB" : there are two modes. under "warm mode" the light is warm color,under "RGB" mode the lamp is Red/Green/Blue..different colors changing.Different modes can be switched by switches in the lamp the color "warm + RGB" contain two leds not six leds. one is warm led another is RGB led Control mode : Normal version: two channels switch: on/off and warm/cold white Warm white + RGB version: three channels switch. on/off and warm white/Color changeable Control mode: Normal version: two channels switch: on/off and warm/cold white .Warm white + RGB version: three channels switch. on/off and warm white/Color How to work: Please put the light under the sunlight 6-8 hours before using it. The light&PIR motion sensor will work after switch turned to "on". In the daytime or where there is light, the lamp will not light up.The light & PIR motion sensor function will be activated at night or in dark area. Avoid usage in extreme environment like these places where is easy to produce stagnant water, no light or poor light or too hot and too cold. Tips:If not work please check these: 1.Confirm switch is on or not. 2.It is light sensor,it can not work in the daytime,it can only work on the darkness. 3.Confirm whether it is being continuously used in a long-term and no charge,recharge it timely before use again. 4.Make sure people moving within the wensing range. 5.Make sure the solar sensor light being installed within the sensing range. 6.Confirm installation direction is correct(solar panel should be facing up). 7.Confirm no objects blocking it and solar panel can receiving sunlight.