<p><strong>Condition:</strong> Brand New<br><strong>Item Type:</strong> UVC Toothbrush Holder</p> <p><strong>Material:</strong> Plastic<br><strong>Size:</strong> Approx. 20 x 7.2 x 4.2cm<br><strong>Ultraviolet Wavelength:</strong> UVA390-410nm<br><strong>Battery Capacity:</strong> 1800mAh</p> <p><strong>Installation Method</strong><br> 1. Choose a suitable location and wipe off dust and water stains on the wall before installation.<br> 2. Heat the double-sided tape on the fixed back plate with a hair dryer to make full use of the viscosity.<br> 3. Tear off the paper from the double-sided tape.<br> 4. Stick the fixed back plate to the wall and press them firmly to release the air.<br> 5. After the fixed back plate is stuck for 24 hours, hang the product at the hole position.<br> 6. Equipped with 4-position toothbrush holder and 3-position toothbrush holder + upper blade holder for selection (development diagram)</p> <p><strong>Charging method</strong><br> 1. If you are using this product for the first time, it is recommended to fully charge it before use.<br> 2. Insert one end of the charging cable into the charging port and the other end into the mobile phone charger (commonly used in 5V-1A mobile phone chargers).<br> 3. During charging, the red light of the charging indicator is on and the display is rotated clockwise. The blue light is always on when it is fully charged, and the indicator panel will show the fully charged state.<br> (When the battery is low, the indicator light flashes red, please charge it in time.)<br> 4. The charging time is about 2 hours (slightly increase or decrease according to the charging conditions).<br> Tip: If you need to clean at the same time while charging, just press the cleaning button to start the 360-second countdown to clean. After cleaning is completed, the screen will return to the charging display.</p> <p><strong>Instructions</strong><br> 1. Open the product cover, put the toothbrush in the toothbrush holder, and close the top cover (Note: Please dry the water on the toothbrush before putting it in the sterilizer).<br> 2. Press the cleaning switch to start the cleaning function. The display will show a cleaning time of 360 seconds and after cleaning, it will automatically turn off.<br> 3. If you want to stop cleaning early, press the cleaning switch to stop cleaning immediately.<br> 4. When the face cover is open, the cleaning function cannot be turned on.</p>