Protects motors from water damage: these 10 pcs motor waterproof pads form a reliable barrier around motor shafts and mounting points to reduce water intrusion and help extend motor life. Secure seal and consistent fit: rubber washers made of plastic sheets provide a dependable seal that helps prevent moisture, dust, and spray from entering sensitive motor areas. Precise size and broad compatibility: each pad has a 2 mm hole diameter, suitable for a variety of small motor applications where a 2 mm shaft or fastener passes through the washer. Lightweight and durable for DIY use: constructed from plastic sheet material, the pads are lightweight yet durable for longterm use in hobby and model-making projects. Easy to install: thin, flexible design slips into place around shafts or bolts for quick assembly and maintenance without special tools. Specifications Quantity: 10 pieces Hole diameter: 2 mm Type: motor waterproof pads / rubber washers Material: plastic sheets Intended use: motor protection in DIY model making Practical applications RC boats and small watercraft: helps shield small drive motors and gearboxes from splashes and spray. Model cars and trucks: protects miniature motors and exposed bearings from dust and light moisture during outdoor runs. Drones and hobby electronics: useful for small motor mounts where a compact waterproofing washer with a 2 mm hole is required. Notes Verify that the 2 mm hole diameter matches your motor shaft or fastener before installation. Designed for lightweight, DIY model-making applications and routine motor protection; not rated as a full submersion seal.