Recessed bathroom spotlight with a click closure for quick and easy bulb attachment. To attach the bulb, push out the inner ring with the glass. The bulb holder cannot be swiveled. Suitable for mounting in cavity ceilings. The attachment uses pre-assembled spring clips on the back. Key benefits - Quick and secure bulb replacement via a simple click closure - Fixed orientation for consistent light direction and reduced glare - Suitable for cavity ceilings with easy back-side attachment via pre-assembled spring clips - No LED transformer required for operation, directly mains powered - IP44 protection for splash water resistance in wet zones - Robust aluminium housing for durability and reliable performance Size and compatibility - Outer dimensions: 90 x 90 mm - Round hole cut-out: 60 to 68 mm - Installation height: 4 mm - Installation depth: 35 mm - Material: aluminium - Protection class: IP44, protection against splashing water on all sides - Protection class II - For mounting in splashing water areas, e.g. directly over the shower Electrical and compatibility details - Socket: cable connection - Dimmable: yes, requires an LED dimmer - Voltage: 220 - 240 V - Rated power consumption: 5 W - Rated life: 20,000 hours - Number of switching cycles until premature failure: 10,000 Light and performance data - Start-up time to reach 60% of full luminous flux: 1 s - Mercury content: 0.0 mg - Dimensions diameter x length: 50 x 25 mm - Beam angle: 90° - Temperature range: -20 °C to +40 °C - Colour rendering index: 80 Ra - Energy consumption: 5 kWh/1000 h - Light colour: warm white - Nominal luminous flux: 350 lm - Colour temperature: 3000 K Use scenarios - In a modern bathroom, recessed in a cavity ceiling above the shower or vanity to provide even, moisture-resistant illumination - In damp zones such as bathrooms or utility areas where splash protection and reliable performance are important - In hallway or corridor transitions near wet areas where a compact, durable 5 W luminaire with a fixed beam is desirable Note: The luminaire is designed for direct mains connection (220-240 V) and requires an external LED dimmer for dimming functionality. The fixture uses a click-closure bulb attachment method with a non- swivel bulb holder and pre-assembled back spring clips for easy installation in cavity ceilings.