Precision cylindrical component — designed for applications requiring a 5 mm internal fit Why this part helps Provides an exact 5.00 mm inner diameter fit to secure, guide, or locate rods, shafts, cables, or tubing that measure up to 5 mm. Fixed 76 mm length gives consistent spacing and alignment over a predictable span, simplifying assembly and repeatable installations. Compact mass (90 g) makes it easy to handle and integrate without introducing excessive weight to small assemblies. Key specifications Inner diameter: 5 mm Length: 76 mm Weight: 90 g Function and compatibility Fits rods, shafts, wires, or hoses with an outer diameter up to 5 mm. Serves as a sleeve, spacer, guide, or alignment bushing where a precise internal bore and a defined length are required. Works with mechanical or electrical assemblies that require controlled separation or constrained movement along a 76 mm section. Practical use scenarios Mechanical spacer: Maintain a consistent 76 mm distance between components on a 5 mm shaft in small machines, fixtures, or prototypes. Cable guide or sleeve: Route and protect cables or thin tubing through a panel or enclosure while keeping them centered and insulated from chafing. Alignment aid in DIY robotics or small equipment: Center and stabilize a 5 mm axle or sensor post to improve repeatability of motion or measurements. Packing list 1 x unit (product as specified) Notes Use the listed inner diameter and length to confirm compatibility with your components before installation. Materials and additional hardware are not specified and should be selected to match your application requirements.