Reduced hand strain and steady cutting Anatomically shaped grip with vibration damping and a non-slip surface reduces hand fatigue and improves control during repeated cuts. Easier to hold firmly and work longer without loss of precision. Precision and control for wire and rope 5 mm precision jaws and a 20 cm (200 mm) plier body deliver controlled, clean cuts on wire and cable. The jaw size provides a predictable cutting window for accurate, repeatable results. Durable, high-performance cutting edge Made from heat-treated chrome-vanadium steel for long-lasting sharpness and reliable cutting power. Designed to cut wire ropes and nails while maintaining edge integrity in regular use. Built to last in demanding jobs Rust-resistant coating and a reinforced pivot joint increase stability and extend the tool’s service life under frequent use. Solid construction minimizes play at the joint for consistent cutting alignment. Key specifications Jaw width: 5 mm (precision cutting area) Overall length: 20 cm (200 mm) Material: heat-treated chrome-vanadium steel Finish: rust-resistant coating Handle: anatomically shaped, vibration-damping, non-slip Pivot: reinforced for increased stability Practical use scenarios Marine and rigging: Trim and terminate small wire ropes and control cables while reducing hand fatigue during repetitive work. Construction and renovation: Cut nails, binding wire, and steel cable for demolition, framing, or fixture installation with precise control. Maintenance and workshops: Use for automotive cable work, equipment repairs, and general maintenance where a durable, precise cutter is required. Why choose this tool Combines ergonomic comfort, precise 5 mm jaws, and durable Cr-V construction for reliable daily performance when cutting wire ropes, cable, and nails. Designed to reduce strain and deliver clean, repeatable cuts with long-term stability.