What this product does Fast-acting 22 x 58 mm fuse that quickly interrupts overcurrents to protect equipment and wiring. Designed to clear faults rapidly and limit damage from short circuits. Key benefits — why you need it Rapid fault clearing: the quick-blow design (schnell wirkender Schlag / schnelles Brennen) stops dangerous currents fast, reducing risk of component damage and minimizing downtime. Wide selection of ratings: available in 10 A, 16 A, 20 A, 25 A, 32 A, 40 A, 50 A, 63 A, 80 A, 100 A, and 125 A to match different circuit requirements. Simple compatibility: standard 22 x 58 mm size fits common fuse holders and panel mount clips that accept this cartridge format. Predictable protection: consistent opening characteristics suitable for protecting sensitive electronics and circuits where minimal delay is required. Important attributes Function: fast-acting (quick-blow) overcurrent protection for low-delay fault clearing. Size: 22 x 58 mm cartridge form factor. Performance: available in eleven defined current ratings (10 A to 125 A) for precise matching to circuit load and protection needs. Construction: built to provide reliable and repeatable operation under overcurrent conditions (refer to your system specifications and fuse holder compatibility). Typical applications (practical scenarios) Power supplies and electronic equipment: protects transformers, switch-mode power supplies, and sensitive electronics from short circuits and component failures where fast interruption is required. Control and instrumentation panels: shields control logic and measurement instruments from sudden overloads and short circuits, preventing damage to delicate components. Test benches and laboratory equipment: provides dependable, quick-acting protection during device testing and troubleshooting where immediate fault clearing is important. Installation and selection tips Match the fuse current rating to the normal operating current and the required protection margin for the circuit. Use the 22 x 58 mm physical size to confirm compatibility with your existing fuse holders or panel cutouts. Choose a fast-acting type when quick interruption is needed; for circuits with high inrush currents, consider time-delay fuse types instead. Ordering information Available ratings: 10 A, 16 A, 20 A, 25 A, 32 A, 40 A, 50 A, 63 A, 80 A, 100 A, 125 A. Size: 22 x 58 mm. Type: fast-acting (schnell wirkender Schlag / schnelles Brennen). Use this fuse where reliable, quick overcurrent interruption is required and verify holder compatibility and amperage selection before installation.