A rugged 3-pin extension cable built for outdoor bike, scooter, and motorcycle use. Extends reach while keeping electrical connections protected from rain, dirt, and cold weather. Key benefits Weatherproof protection: IP66 rating keeps water and dust out of the connection so components keep working in rain or wet conditions. Adds installation flexibility: 800 mm length gives enough reach to reroute wiring or relocate controls and lights without stretching or splicing. Durable and flexible: Plastic and rubber construction resists outdoor wear and stays flexible in low temperatures for easier routing and secure connections. Broad compatibility: Works with bike lights, accelerators/throttles, e-brakes, PAS sensors, operation buttons, and display screens that use a standard 3-pin connector. How it solves common problems Fixes short cables: Avoid awkward device placement or risky splices by adding a reliable 800 mm extension. Protects critical electronics: Reduces water-related failures by sealing the connection to IP66 standards. Simplifies upgrades and repairs: Swap or extend components quickly without replacing original wiring harnesses. Typical use scenarios E-bike handlebar upgrade: Move a handlebar display to a more comfortable position without altering factory wiring. Scooter or motorcycle light relocation: Extend the rear or auxiliary light wiring when installing rack mounts or aftermarket accessories. Replacement/repair on trail or commute bikes: Replace a damaged connector or extend PAS sensor wiring to restore safe operation. Specifications Connector: 3-pin extension cable Length: 800 mm Waterproof rating: IP66 Materials: Plastic and rubber Compatible with: Bike lights, accelerators (throttles), e-brakes, PAS sensors, operation buttons, display screens Designed for: Bicycles, motorcycles, scooters Easy to install, built for outdoor conditions, and sized to accommodate most common two- and three-wheeled vehicle wiring modifications.