2 PCs 25 W Load resistor for LED lamps false resistors for LED lamps CANbus stop light Flicker Load resistor-on-board network trick/deceptive module. With a capacity of 25 watts. To eliminate errors in the on-board computer, it is necessary to install a load resistor (SNAG) in the LED lamp circuit. The load resistor additionally creates resistance in the electrical circuit. For less powerful LED lamps, external dupe resistors with less power dissipation are used. For example, when replacing incandescent lamps of the w5w/c5w type with a rated power of 2-5W. (usually installed in the dimensions, number lighting, interior lighting), false resistors with a dissipated power of 25 W are used. Automotive systems for checking the performance of components and parts are being improved every year, changing the verification algorithms accordingly. LED lamps consume much less energy and do not close the eclectic circuit, like a filament of a lamp. When installed, they are connected to the circuit up to the LED lamps by means of special clips on the wires without breaking, soldering and twisting, which facilitates and speeds up the installation process. Load resistor or "snag" is used to prevent rapid flashing of LED lamps in the direction indicators or to turn off an error on the on-board computer after installing any LED lamps in the feet, dimensions, number, Dho, and so on. The trick will bypass any check and disable the message about any error. The power of the resistor is not the power consumed by it! This is the maximum power dissipation! That is, the amount of energy that the resistor can dissipate without overheating and burnout. Installing a 25-watt dissipation resistor instead of a 21-watt incandescent bulb does not increase the load on the onboard network. Resistor is suitable for any passenger car. When installing the resistor, you do not need to cut the wires or interfere with the wiring of the car. Resistors are easy to install and easy to remove. The resistor is attached to the standard wiring using two red plastic couplers, which are attached to each resistor. The resistor must be installed for each turn signal lamp. If 2 LED lamps are installed, for example only for rear direction indicators, 2 resistors must be installed. If 4 LED lights are installed, in the front and rear direction indicators, you need to install 4 resistors, one for each lamp. When installing resistors, you do not need to observe polarity, T. K. Resistors do not have it. Attention! Resistors are highly heated during operation. To improve the heat sink, it is necessary to fix the resistor on the metal of the car body. When installing the resistor, it is necessary to make sure that the resistor body does not touch and vehicle parts that can melt under the influence of temperature (for example, thin plastic or wiring). Main characteristics: -Name: Fake, resistor, resistance for LED -Car : any cars, motor vehicles, special equipment -Lamp type: LED lamp, daytime running lights, auto light diodes, fog lights, etc. -Voltage: DC: 6-16V -Maximum power: 25 W -Rated resistance: 3ohm/6ohm/8ohm/10ohm/25ohm (optional) -Dimensions (D * W * T): approx. 40*15*15mm -Wiring Length: 14 cm (each side) Package includes: -2 PCs * LED lamp resistor _x000D_ _x000D_