Description Specification: Type: Light curing composite resin Shade: A1, A2, A3 Net weight: 2.5g Color: As shown in picture Quantity: 1 piece Features: 1. Low polymerization shrinkage 2. High strength and polishability 3. Similar modulus of elasticity to dentin 4. Radiopaque and fluoride releasing 5. Optimal polishability and high shade stability 6. Easy to mold 7. Easy to adhere to bracket for orthodontics 8. Simple and convenient to use 9. Suitable for all types of cavity preparations Usage: 1. Prepare cavities according to standard procedures, remove decayed tissue, and clean the cavity. 2. Apply a dental etchant to the tooth surface to be bonded, then rinse and dry thoroughly. 3. Apply a thin, even layer of dental adhesive to the bonding surface and cure with a dental light-curing unit for 20 seconds. 4. Fill with an appropriate amount of composite resin, shape as needed, and cure with a light source of at least 400 mW/cm² for 20 seconds. Curing depth is approximately 1.5 mm. For deeper fillings, extend curing time or use incremental layering technique. 5. Perform finishing and polishing. Use dental articulating paper to check occlusion before final trimming. It is recommended to use rubber polishing points and ultra-fine abrasive polishing strips. 6. When indicated, use pulp protection materials such as light-cured or chemical-cure calcium hydroxide or other non-eugenol containing liners. Do not use eugenol-containing materials directly under the restoration. Intended Use: For non-occlusal cavity restorations. Warnings: Close the cap immediately after use to prevent exposure to light. Not recommended for use in cases of pulpitis. If pulp exposure or proximity is present, perform proper pulp capping and protective treatment prior to placement. Other pulp conditions should be treated appropriately before restoration. Storage: Store at room temperature and protect from direct sunlight.