The 150 x 10 mm End Cap Oil Seal is supplied as 1 piece. It is designed to seal endcap interfaces, retaining lubricant and preventing contamination in rotating or sliding assemblies. The 150 x 10 mm size specification identifies the fitment requirement for equipment configured to this seal dimension, helping to ensure proper installation and reliable performance. Key attributes Size: 150 x 10 mm Type: End Cap Oil Seal Quantity: 1 piece Function: seals endcap interfaces to retain lubricant and exclude contaminants; supports bearing life Design: simple onepiece seal suitable for endcap installations Material: not specified in the listing; consult the supplier or data sheet for material composition Compatibility: intended for systems requiring an oil seal of 150 x 10 mm; verify fit with equipment manual Performance: provides oil retention and protection against dirt ingress under typical operating conditions Installation notes: ensure mating surfaces are clean; use appropriate tooling to seat the seal correctly Applications Replacing a worn seal in hydraulic cylinder end caps to prevent oil leakage and ingress of contaminants Sealing the end cap of a small gearbox or electric motor to maintain lubrication and protect internal components Replacing endcap seals in pump housings to ensure oil containment and extend service intervals This description reflects the product's stated size and purpose, maintaining a professional and clear tone to support informed decisions.