Applications Range The inner tie rod removal tool features a 3/8' plug that fits most common car chassis rocker arm inner tie rod sizes and all standard tie rods with smooth cylindrical ends. Widely used in automotive applications, it meets a wide range of chassis adjustment needs. Material Advantages Made from carbon steel with good wear resistance and strong corrosion resistance. The Utooth construction increases friction and provides a fit on the inner rocker arm during removal, making it easy to secure and operate the chassis rocker arm. Practical Design The tool adopts a Ushaped design, allowing the arm to fit with the inner tie rod of the chassis rocker arm, providing better stability and accuracy. The lowprofile design enables the inner tie rod to be removed without pulling out the outer tie rod. Compability It is an ABN 3/8 inch inner tie rod tool removal tool that eliminates the need to pull out the outer tie rod. Any tie rod that fits between the 3' upper and lower parts after screwing on and tightening the two 9/16' nuts will fit. Use scenarios Replacing inner tie rods on vehicles with standard smoothended inner tie rods, so you can remove the inner rod without disturbing the outer tie rod. Working in tight engine bays or crowded suspension areas where a lowprofile, stable tool improves control during removal. Servicing chassis adjustment across multiple makes/models that use a range of inner tie rod sizes, leveraging the 3/8' plug and broad compatibility.