Specification: _x005f_x000D_ Origin: Mainland China _x005f_x000D_ Type: PCI-E Riser _x005f_x000D_ Product size: 52.00x36.00x5.00mm _x005f_x000D_ Product size: 2.05x1.42x0.2inch _x005f_x000D_ Standard: SD specification VER2.0, IDE/ata-33; _x005f_x000D_ Standard IDE interface: true IDE mode, and supports DMA-33 transmission mode; _x005f_x000D_ The IDE interface is a 44-pin/2.0mm male connector; _x005f_x000D_ There are two main control chips on the board and an SD card slot on the back; _x005f_x000D_ Advantages: small footprint, exquisite design, simple operation; _x005f_x000D_ The SD card can be a device that contains the operating system and application software and can be directly booted; _x005f_x000D_ Supports DMA and ultra DMA modes, suitable for DOS, for NT4, for windows98se, me, 2000, XP, vista, for Linux systems _x005f_x000D_ Installation Notes: _x005f_x000D_ First install the SD card into the slot, and then connect the hard drive's data cable to the laptop hard drive interface. It can be operated after the power-on test is normal. It's that simple, no need to drive anymore _x005f_x000D_ _x005f_x000D_ _x005f_x000D_ Note: _x005f_x000D_ This adapter does not support hot swapping of CF cards. Please turn off the power when replacing the card. _x005f_x000D_ Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you! _x005f_x000D_ Please allow 1-2cm measuring deviation due to manual measurement. _x005f_x000D_ _x005f_x000D_ _x005f_x000D_ _x005f_x000D_ Included: _x005f_x000D_ 1 x SD Card to 2.5 Inch IDE Adapter