Scope of application: 18650 special lithium battery protection board, scooter, drift car protection board, solar street light, LED protection board, motorcycle lithium battery protection board, tricycle power protection board, backup power lithium battery protection board Continuous Discharge Current: 30A.Instantaneous discharge current:100A. Charging voltage: 60V. Maximum charging current: 30A Overcharge detection voltage: 3.75±0.025V. Overcharge protection delay: 100±30ms. Overcharge release voltage: 3.6±0.05V. Battery balance detection voltage: 3.6±0.025V. Battery balance release voltage: 3.6±0.05V. Battery balance current: 36±5A. Overdischarge detection voltage: 2.1±0.08V.Overdischarge detection delay: 100ms. Overdischarge release voltage: 2.3±0.1V. Overcurrent detection voltage: 150mV. Overcurrent detection delay: 10ms. Overcurrent protection current: 130±20A. Overcurrent protection release disconnect load. Short circuit protection external load short circuit Short circuit detection delay: 200uS Short circuit protection release disconnect load Main circuit conduction internal resistance: less than equal 15mohm Working current: less than equal 50uA Sleep current (when the battery is over-discharged): less than equal 10uA Temperature range: -30/+80°C Connection Using: 1. First connect the B- line to the battery negative terminal (the B- line must be soldered with a short wire), and then connect the flat cable (before connecting the flat cable, be sure to unplug the flat cable from the board) 2. Start wiring from B-, connect B- to the total negative electrode of the battery, connect the second cable B-1 to the first positive electrode of battery, and connect the third cable B-2 to the second positive electrode of battery, and the fourth cable B-3 is connected to the third positive electrode of battery...and so on 3. Finally, measure whether the total battery vo