Specification: Name: 6-port SATA3.0 expansion card Model: PCE6SAT-M01 Master control: for 88SE92xx+109X Interface: PCI-E 1x, 2x, 4x, 8x, 16x Support system: for WINXP / WIN7 / WIN8 / WIN10 / LINUX Bus interface: PCI-x1 slot Expansion interface: 6 SATA3.0 interfaces Product size: approx. 12 * 10 * 2cm / 4.7 * 3.9 * 0.8inch The PCIE to SATA3.0 riser card is used as follows: First, the system disk and PCIE to SATA3.0 riser card connection conditions and solutions: 1. The SATA interface mode of PCIE to SATA3.0 is AHCI mode. If you want to plug in the system disk on our card, the premise is that your system disk must be installed in AHCI mode when installing the system on the motherboard. Otherwise, the system cannot be started through our transfer card. 2. If it is determined that the SATA interface installation system of the system disk inserted in the motherboard is AHCI mode, then you can directly insert the hard disk into our card, and then enter the motherboard BIOS to set the system disk as the first boot. 3. If the above two conditions are met, if the hard disk interface of the motherboard still fails to start, or restarts repeatedly, it may be caused by the conflict between the hard disk interface of the motherboard and our transfer card. The solution is to enter the motherboard BIOS and set the hard disk interface option of the motherboard to Disabled, then save and restart to start the system. Package List: Riser card *1 Half height baffle *1 Super High Speed: Supports communication speeds of 6.0Gbps, 3.0Gbps and 1.5Gbps. Control Stability: Supports FIS based on port multiplier switch or command switching. Local Command Queue (NCQ). Good compatibility: Compatible with SATA6G, 3G and 1.5G hard drives. Support AHCI1.0 mode and IDE mode. Hot swap. 4 SATA. Compliant with Serial SATA 3.0 specification, backward compatible with SATA2.0 and SATA1.0. Compliant with PCI v2.0 specification, backward compatible with PCI v1.0.