Product Introduction: MKS CANable V2.0 module is an upgraded version of MKS CANable V1.0. CANable V2.0 is a compact, low-cost, open-source USB-to-CAN analyzer. It enumerates as a virtual serial port on your computer and provides a serial interface for CAN bus communication. CANable V2.0 supports CAN 2.0A, CAN 2.0B, and CAN FD. When using the candleLight firmware, it appears as a native CAN interface on Linux systems. The CANable analyzer is compatible with ARM-based embedded platforms, including Raspberry Pi, Raspberry Pi Zero, ODROID, and BeagleBone, making it suitable for product integration. Product Features: 1. Supports CAN 2.0A and CAN 2.0B; baud rate up to 1 Mbps. 2. Compatible with candleLight and slcan firmware; slcan supports CAN FD with test rates up to 2 Mbps and 5 Mbps. 3. Terminal resistor can be enabled or disabled via jumper. 4. Equipped with USB Type-C interface; supports online firmware upgrade and DFU mode firmware upgrade. 5. Powered by high-performance ARM Cortex-M4 STM32G431C8T6 processor, operating frequency up to 170 MHz. 6. Includes schematic diagram, firmware, source code, and host software — comprehensive resources for development and use. Analyzer Board Version: V2.0 Material: ABS Color: As Shown Package Contents: 1 x USB data cable 1 x 3-pin double Dupont cable 1 x analyzer board Note: The package includes only the items listed above. Other accessories are not included. Color appearance may vary slightly due to lighting conditions and screen settings. Measurement tolerance: ±1–3 cm.