Motorcycle Heated Anti-Fog Visor Film for Helmet – Clear Lens Patch（with temperature control） Motorcycle Heated Anti-Fog Visor Film for Helmet - Clear Lens Patch NOTE: PRICE IS FOR THE HEATED VISOR,NOT INCLUDE THE HELMET VISOR！！！ NOTE: PRICE IS FOR THE HEATED VISOR,NOT INCLUDE THE HELMET VISOR！！！ NOTE: PRICE IS FOR THE HEATED VISOR,NOT INCLUDE THE HELMET VISOR！！！ SPECIFICATIONS Helmet Material: Abs Weight: 0.25 Item Type: Helmets Helmet Style:Full Face Choice: yes Motorcycle anti-fog helmet visor ultra-clear electric heating long helmet lenses patch film electric heating anti- fog lenses The only lens that can be heated Product introduction heatenergyonthesurfaceofthelenstoheatupandpreventwatervaporfromcondensingon thesurfaceof thelens,therebyachieving thefunctionofanti-foganddefrosting Electric lens parameter table（as picture） How to install the product 1. Open the box and take out the positioning film, stick the positioning film on the outside of the helmet lens, pay attention to the distance between the upper edge of the lens and the electric heating lens (Area A) as far as possible to be greater than 15mm, to avoid scratching the waterproof tape on the helmet when the lens is opened; 2. Remove the helmet shield lens, clean the inside of the lens (the side of the face), flip the lens and place it on a clean table; 3.Tear off the release paper of 3M glue on both sides of the electric heating lens (remember not to tear offal the release paper), bend the electric heating lens to an arc similar to that of the helmet shield lens, and paste the electric heating lens on the helmet shield lens.inside; 4.After the position of the electric heating lens is finally determined, tear off the release paper of the remaining 3m adhesive strip and press the adhesive strip; 5. Tear off the release paper on the adhesive surface of the FPC flexible cable, and turn the flexible cable from the inside of the helmet shield lens to the outside of the helmet shield lens (the flexible cable is reserved in the power box with a length of 8-20mm, and loosen it The screw can gently pull the cable to increase the length), tear off the 3m adhesive release paper of the external power supply box, paste the external power supply box in a position that does not affect the line of sight,tear offthe protective film on the surface of the electric heating lens, tear off the positioning film, and put the helmet on. The visor lens is put back into the helmet; 6. Paste the wire socket on the helmet to fix the wire plug; 7. Connect the car power cable to the 12V car power supply (red positive, black negative) or connect the USB cable to the 2A output port of the power bank.