2Set Adjustable 3 Point Seat Belt Kit Inertia Retractable Universal Car Safety Belt for Sedan Trucks Van UTV RV Forklift Bus Specification Name: 2Sets Adjustable 3 Point Seat Belt Kit Item Type: Car Seat Belt Condition: 100% New Color: Black Material: Polyester, ABS Plastic, Stainless Steel Opening Force: 10 N-60 N Tensile Strength: 26700 N Thickness: 1.2mm/ 0.05" Belt Width: 4.8cm/ 1.9" Belt Maximum Length: 340cm/ 133.9" Belt Buckle Length: 30cm/ 11.8" Mandatory Mounting Angle: 90° Quality Mark: E24 (belt is provided with sewn-on label to the belt band) Vehicle Category: M1, M2, M2, N1 and N2 Placement on Vehicle: LV (driver), RV (co-driver), LA and RA (rear seat, outer rear seats) Fitment Type: Direct Replacement Package Include: 2pcs Retractor with Strap 2pcs Belt Buckle 8pcs Mounting Bolts (M11) 8pcs Nuts (M11) 10pcs Metal Washers 8pcs Plastic Washers 2pcs Plastic Cover Cap Package Weight: 2370g/83.6oz Package Dimensions:approx. 300 x 100 x 100mm/11.8 x 11.8 x 3.9in Description 2Set 3-Point Inertia Seat Belt Kit Adjustable Retractable Car Safety Belt *This 3-point belt is E24 approved for the best security, easy to install and you can loosen it easily and quickly. *Provide added safety during driving for the driver and the passenger by being firmly secured in the seat. *High quality polyester fabric strap provides high tensile strength. The buckle lock is firm and thermal-resistant, safe and secure. Installation Guidelines Step # 1: Remove existing seat belt and components including the female end on the console side. Step # 2: Place the retractor bolt through the bolt hole on the new retractor. Screw the bolt into the anchor point at the bottom of the B-pillar Step # 3: With the retractor mounted, pull the shoulder mount up to the factory anchor point on the upper B-piller. Place the thread bolt through the bolt sleeve. Run bolt and sleeve through the shoulder mount and thread into the factory anchor point. Install plastic cover cap. Note: Mount the retractor at a 90°orientation in the vehicle. Step # 4: Using a stock bolt, mount the belt end to the factory anchor point. The mounting point is on the outboard side in your floor pan or on the floor pan. Insure that all bolts are tightened completely. Step # 5: Install the female buckle end of the seat belt on the console side of the floor pan. If a factory anchor point exists on the side of the transmission tunnel, bolt directly to the factory anchor point. Note: 1. Please check the size, type and shape of the product before buying 2. This belt does NOT have a sensor. It does NOT have the electrical connection 3. Please allow minor differs due to manual measurement 4. The picture may be a little different from that of real item due to the different display and different light 5. Due to different producing batches, product details might be a little different _x000D_