Magnetic head assembly for pedicure spa chair jet motor, designed for pipeless whirlpool spa chairs and magnetic induction pumps.Key benefits Leakresistant design: no shaft seal eliminates shaftseal leak points and reduces maintenance concerns. Simple maintenance: magnetic impeller and cover are easy to remove, clean and service. Direct replacement: designed to fit magnetic motordriven jets, providing straightforward installation and reliable operation. Complete set: includes base, magnetic impeller and cover for a readytoinstall or upgrade.Specifications Rear head diameter: 3 3/8 inches Front head diameter: 3 1/8 inches Kit contents: 1 base, 1 magnetic impeller, 1 cover Function: pipeless magneticjet head for spa chair massage pumps Compatibility: compatible with magnetic motors used in Luraco jet motor systemsPractical applications a worn or damaged magnetic head in a spa chair to restore jet performance and stop leaks. Retrofit a pipeless massage pump during routine spa maintenance to take advantage of a magnetic drive design. Keep a spare magnetic head assembly on hand for salon technicians to reduce downtime during chair servicing.Precautions1. On start, the magnetic induction pump checks for sufficient water for up to 15 seconds. If insufficient water is detected within 15 seconds, the pump will automatically stop.2. To restart after an automatic stop, cut power to the unit and then start again.3. If the product does not operate, check the pump for faults before replacing components.4. For unresolved issues, contact your equipment supplier or service provider for assistance.This magnetic head assembly provides a practical, easytoservice solution for spa chair jet maintenance and replacement while maintaining compatibility with magnetic motor systems.