Decking and Floor Board Straightening Tool A compact, multiangle tool designed to align, bend, and adjust decking and floor boards during installation and . Built from alloy with steel contact points and finished in red for easy identification on the jobsite. Why you need this tool Ensures straight, consistent board alignment to reduce gaps and uneven edges during decking and flooring installation. Speeds up installation and by providing controlled bending and precise adjustment of boards without repeated trial and error. Reduces the need for makeshift clamps and excessive force that can damage boards. Key benefits Multiangle adjustment lets you apply controlled force at different angles for straightening, bending, or holding boards while fastening. Durable alloy body with steel contact surfaces for long service life under regular carpentry use. Compact and lightweight design for easy handling, positioning, and transport between work areas. Red finish helps keep the tool visible among other hand tools and materials. Features and attributes Function: Straightener, board adjuster, and bender for decking and floor carpentry. Compatibility: Suited for wood decking boards, floorboards, and similar carpentry materials during installation and . Material: Alloy body with steel working surfaces for strength and wear resistance. Color: Red finish for visibility. Adjustment: Multiangle operation to accommodate different board widths and bend requirements. Use: Handoperated tool intended to assist in aligning, prebending, and holding boards in place while fixing. How it solves common problems Corrects warped or cupped boards before fastening, improving the finished surface and reducing rework. Holds boards steady for screw or nail placement, preventing slippage and misalignment. Applies targeted pressure without crushing or splitting the board when used as instructed. Typical use scenarios Installing an outdoor wood deck where several boards need slight straightening for an even seam before fastening. Repairing indoor floorboards that have become misaligned or cupped, using the tool to reposition boards for smoother transitions. Holding a board in the correct angled position while preparing to screw or glue it into place during carpentry or renovation work. Usage tips Position the tool so steel contact surfaces bear evenly on the board. Adjust angle to match the correction needed before applying steady force. Use in combination with clamps or temporary fasteners when holding a board for final fixing. Inspect contact surfaces for debris before use to avoid marking the board surface. This straightforward, multiangle board straightening tool is designed to be a practical addition to carpentry and decking toolkits, providing controlled adjustment and durable performance for everyday installation and tasks.