Replacement snowblower traction drive cable designed as a directfit aftermarket replacement for compatible snowblower models. Use this cable to restore traction drive control and worn, stretched, or broken cables. Key benefits Restores traction drive operation so the snowblower responds correctly to the drive lever. Directfit replacement for listed models and part numbers, reducing installation time. Adjustable spring end allows fine tuning for proper engagement. Compatibility and replacement part numbers Fits MTD snowblower models: 312610E000 (1992), 313610E120 (1993), 314616E131 (1994). Fits equipment using part numbers 9460898, 7460898, 7460898A, 7460898B, 290904, 5616. Will also fit some YardMachine snowblowers. Confirm model and part number before ordering. Dimensions and adjustment Cable length (bare): 35 inches Total assembled length with both ends: 43 inches Cable with spring end length: 37 inches, adjustable for proper fit Function and application Designed to operate the traction drive linkage on compatible twostage and singlestage snowblowers. Intended as a replacement part to maintain safe and predictable drive engagement. Typical use scenarios a stretched or frayed traction cable discovered during prewinter maintenance to restore consistent drive engagement. Install while repairing a snowblower whose traction control stopped engaging or slipped during operation. Keep a replacement cable on hand for seasonal equipment servicing or to support quick repairs in the field. Installation notes Intended as a direct replacement; check vehicle model and part number compatibility prior to installation. Adjustment of the spring end may be required to achieve correct tension and engagement. This aftermarket replacement cable matches the listed part numbers and model compatibility to make routine and maintenance straightforward.