Features: This LED ground light is designed to lead vehicle and pedestrian to right direction. Viewing distance up to 500 meters, which can effectively provide the driver with safe driving direction. Solar power design, using LED as light source, energy saving and environmentally friendly. It is recharged by solar panels under sun light, automatic charging during the day, automatic lights up at night. Durable casting aluminum construction can deal with the outdoor environment, durable and waterproof. With large reflective light brightness. The reflective light brightness can reach 2000mcd, which is 6 times~7 times that of the ordinary spike light, and the lamp bead is more than 6000cmd. Active lighting, not only can avoid the interference of rain and fog to the greatest extent, but also can make the driver's line of sight get rid of the dependence on the car lighting, the visual distance is farther, the effect is better. Specification: Condition: 100% Brand New Material: Die-cast aluminum housing + reflective sheet + PC Solar panel: 2.5V/120MA monocrystalline silicon Energy storage device: 1.2V/600MAH NI-MH/high temperature resistant NI-MH battery Working duration: charged a day under standard light strength, it can work for 40 hours; the battery can work continuously for more than 72 hours after being fully charged Light mode: flashing or constantly bright Light color: White Light source: 6 * 5MM super bright anti-fog LED lights Visible distance: >500 meters Illuminance: 400-500 lx Life-span: 3-5 years Working environment: -20°C ~ +70°C Waterproof: IP68 Static crush resistance: ＞20 tons Installation Steps: 1. Positioning: Firstly, use the ruler to determine the installation position, ensure that the longitudinal position of each position is on a straight line, the installation distance and design requirements shall prevail, and the installation site shall be flat, dry, clean and seamless. 2. Mixing glue: using dedicated A glue and B glue, A glue and B glue ratio is 1:1 (such as: 1 kg A glue, 1 kg B glue) glue must be evenly mixed, consistent color. 3. Applying glue: the road surface should be cleaned during installation, the glue should be moderate, not only stick to the ground, but also do not overflow too much, about 40 grams of glue per lihgt, apply glue to the bottom of the road sign. Clean up the road debris after installation. 4. Patrol: check the installed spike lights after two hours. 5. Road closure: It is recommended to close the road for 6 hours to ensure the curing time of the glue. Package list: 2 * Road Ground Lights Note: Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.