EBay Features: 1) Long distance APP remote control via WIFI; 2) Support routing mode (AP) and LAN connection mode (STA); 3) Support almost every kind of one-wire or two-wire LED driver IC; 4) Brightness adjustable, with 180 kinds of patterns and 8 kind of color adjustable patterns; 5) Creatively using from-image-to-effect method for user to DIY any effect; 6) Support setting pixel number and segments number, able to control up to 2048 pixels; 7) DC5V~24V wide range working voltage, preventing reverse connection of power supply; 8) User setting saving; Specification Working Temperature: -20~60 Degrees Celsius Working Voltage: DC5V~24V; Working Current: 20mA~130mA; Remote Distance: 30 Meters; Product Size: 85mm*45mm*22mm; Product Weight: 40g; Certificates: CE, RoHS; Package includes: 1x SP108E WIFI LED controller 1x 3pin female JST connector 1x Mini screwdriver 1x User manual (Note: power supply/mobile/controller/led strip not include!) Note: Can not use 5.0G WIFI network, it just support 2.4G WIFI network AP (Access Point) mode: Controller and Phone connect directly, controller works as an access point. Connect steps: When the device is not connected to any WIFI network, power on the controller and wait for 20s and then controller will switch into AP mode; In the WIFI setting page, find and connect the controller (named likeSP108E_xxx, the default pin code is 12345678), Open the LED Shop App, then the controller will be showed on the device lis STA (Station) mode: Controller and phone are in one same WIFI network, in this network, users can operate the controller smoothly. Connect steps: When the device is not connected to any WIFI network, power on the controller, controller will be remain in Wait-For-Connect mode for 20 seconds; Make sure that your phone is connected to a WIFI network, Open LED Shop APP, pressing the Add Device button, input the WIFI pin code, then press the OK to confirm and wait for the configure processing finish; When controller successfully enter the WIFI network, it will be showed on the device list; User can select the controller and remove it out of the network by pressing the Remove Device button, then the controller will switch into AP mode.