USB C 3.2 SSD Enclosure compatible with SSD 12+16 PIN Pro, Air, Pro, , SSD Enclosure

[Higher Compatibility] This USB C 3.2 SSD enclosure works well compatible with SSDs with 12+16 Pins. It comes with a M.2 NVME SSD adapter also support m.2 2280 NVME SSDs.DOES NOT support compatible with 12+16 PIN SSDs (please make sure your SSD in is not a compatible with one becompatible withe purchase). NOT compatible with all SSDs, or SSDs. [Faster Data Transmission] 10Gbps transmission speed with USB 3.2 Gen2 interface. Save and transfer data in a seconds. It can also reach 20Gbps transmission speed with USB 3.2 Gen2x2 if the computer supports. [Friendly Design] USB C 3.2 SSD enclosure is sturdy and portable, with aluminum alloy case compatible with quicker heat dissipation. To prevent it from being disconnected from your compatible with or PC, we advise you: 1.put PCB back into the enclosure and tighten the screws to use (which also help dissipate heat effectively);2.deselect "Put hard disks to sleep when possible" both in Battery and and Power Adapter. [System Requirements] USB C 3.2 SSD Enclosure supports 2013-2017 compatible with , 2013-2015 compatible with Pro Retina, 2013-2014 compatible with , 2013 compatible with Pro. supports direct read on compatible with OS, if using on compatible with , you need to recreate the new file compatible withmat [Easy Installation] Just take out the PCB board from the enclosure,then fully insert SSD to card slot of the PCB board, we advise you put PCB back into the enclosure and tighten the screws to use. So it can get effective heat dissipation or it disconnected in your compatible with or PC. Plug and play, support hot plug.On compatible with OS, hard disk on "This PC"/ "My computer", please find your drive from "Disk Management". Color: Grey Material: Aluminum Alloy Package Contents: 1 x hard drive box 1 x data cable Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.