12V 24V 800W MPPT charge controller for wind turbines

12V 24V 800W MPPT Charge Controller for Wind Turbines 1. Automatically charges the battery. 2. The rectifier and braking circuit of this controller uses an integrated module, offering superior heat dissipation and reliability. 3. Adopts a fully sealed and waterproof design, achieving a protection rating exceeding IP67. It can be used normally even underwater for extended periods. Notes: Ensure that the output voltage of the wind turbine generator matches the nominal voltage of the battery. Connect the wires in the following order: first connect the positive and negative terminals of the battery, and then connect the three-phase voltage output of the fan. Connect the battery and wind turbine to the controller according to the instructions. Reverse polarity or incorrect positioning will result in abnormal system operation or even complete damage to the controller. Wiring Mode: 1. Connect the positive and negative terminals of the battery to the positive (red) and negative (black) terminals of the controller's battery. 2. Connect the three-phase output voltage of the wind turbine to the three-phase input terminal (green wire) of the controller fan. Parameters: 1. Maximum input AC voltage: AC 35V 2. Output voltage: 12V / 24V 3. Battery charging cutoff voltage: 14.5V 0.3V / 29V 0.3V 4. Maximum charging current: 15A (12V) Maximum charging current: 10A (24V) 5. Wind generator speed limiter voltage: 14.5V 0.3V, 29V 0.3V 6. Protection rating: IP67 7. Static current draw: 0.008A 8. Storage power: 800W 9. Maximum storage wind speed: 0.12 10. Operating temperature: -35°C - 65°C 11. Input wiring: Three-wire system 12. Control mode: 12V / 24V compatible 13. Installation: Screw-on 14. Do not reverse the positive and negative terminals to avoid burning out the controller. Application: Wind controller Color: Blue Material: Aluminum alloy Package contents: 1 x MPPT wind generator controller Only the above package contents, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture to be slightly different from the real thing. The allowable measurement error is +/- 1-3 cm.