DC12V/24V 5M Head 800L/h Aquarium Water Pump DC Submersible Pump Small Booster Pump Low Noise Pump DC Female Connector

Voltage: DC12V (Applicable Range: DC 7-14V) / DC24V (Applicable Range: DC 5-28V)Type: Bare Wire / DC Female Connector 5.5x2.5mmPower: 12V 19W / 24V 22WFlow Rate: 13L/minHead: 5.5MProduct Information: Bagged, Packaging Dimensions: 8*7*5cm, Weight: 220g, Quantity: 1.Product Features:o Maintenance-free, small size, high efficiency, low power consumption, strong anti-interference ability, stable operation.o Brushless, pollution-free, electronic commutation, long lifespan.o The pump's lower mounting plate can be replaced with shock-absorbing silicone to absorb vibration and reduce noise. The silicone position is adjustable for easy installation.The stator and circuit board of the motor are encapsulated with epoxy resin and completely isolated from the rotor, solving the leakage problem that occurs during long-term submersion of DC water pumps, making them completely waterproof.This solves a series of problems that occur in complex environments, such as pump jamming and sudden failure to start.The pump shaft uses high-performance ceramic (zirconia) (stainless steel shaft is optional for cost reduction), offering high precision and good wear resistance, thanks to the precise fit between the high-precision bushing and the ceramic shaft.Pump parameters, such as voltage and head, can be adjusted according to requirements without changing the size, allowing for wide voltage operation.The mortality rate of water pump drives has been reduced. Currently, the mortality rate of water pumps on the market is approximately 2% to 3%. Extensive research has reduced the mortality rate to less than 0.05%.Optional speed control functions are available (PWM speed control, 0~5V analog signal speed control, potentiometer speed control).To increase the pump head, the pumps can be connected in series, doubling the head.o Amphibious (Installation position below the water surface when used externally)Precautions:1. This is a submersible centrifugal pump. The pump must be submerged in water, or the water level of the external source must be lower than the pump's inlet nozzle to allow air to escape after water enters the pump's inlet chamber, enabling normal pumping.2. When selecting a pump, please specify the operating environment: such as continuous operating time, water temperature, and medium. Pumps with a power exceeding 24W are not suitable for continuous operation at water temperatures above 65 degrees Celsius. Please consult with a professional to select the most suitable pump model!3. The current mentioned above is the pump's open-circuit current, i.e., the current when the pump is directly placed in water without any system connection, which is also the pump's maximum current. When the pump is connected to a system, the operating current will decrease to 70%-85% of the maximum load current.4. The pump's head is the maximum delivery height, meaning the flow rate at the maximum head point is zero.5. The pump's flow rate is the horizontal flow rate, i.e., the flow rate for horizontal pumping.6. This water pump cannot operate for extended periods without water.Note: 1. Due to differences in monitor displays and lighting effects, the actual color may differ slightly from the image!2. Please allow for a 1-3 cm deviation due to manual measurement!