2pcs M8x250mm 304 Stainless Steel Double End Threaded Rod, RustResistant Precision Length Adjustment for Mechanical Parts

Stainless steel adjustable push rods for RC models and hobby builds Product highlights Durable stainless steel construction for long life and resistance to rust in typical hobby use. Threaded, twotip length design provides precise, tight adjustment for pushrod length and alignment. Stable connection for control linkages, landing struts, and other structural bracing where a secure mechanical link is required. Versatile compatibility with DIY remote control models, model toys, gear shafts, motor shafts, short support shafts, and shaft pocket models. Why you need this Reliable mechanical linkages: The threaded pushrod lets you finely tune rod length and tension, ensuring consistent control surface response and reduced play in linkages. Corrosion resistance and strength: Stainless steel resists common workshop and outdoor conditions while providing the stiffness needed for accurate pushrod operation. Simple integration: Designed to connect construction columns and accessories with different bracing, fuselage sections, landing struts, or heavyweight plane control rods without complex modifications. Key features and function Material: quality stainless steel for durability and rust resistance. Adjustment: Threaded twotip length configuration enables precise, secure length changes and tight fastening. Function: Used as a steel pushrod for RC airplanes and model assemblies to transfer motion or provide structural support. Compatibility: Suits a wide range of remote control models and model toys that use gear shafts, motor shafts, or short support shafts. Practical use scenarios RC airplane elevator or aileron linkage: Install the threaded pushrod between a servo arm and control horn to allow fine length adjustment and reduce linkage play. Landing gear and fuselage bracing: Use the pushrod to connect landing struts or bracing columns where a sturdy, adjustable link is required. Model motor and gear assemblies: Secure the pushrod on gear shafts or motor shafts and in shaft pocket models to stabilize small rotating parts and supports. What to expect Sturdy, lowmaintenance components that simplify setup and maintenance of hobby models. Precise mechanical adjustment for improved fit and reduced slop in linkages. Note: Intended for use in DIY remote control models and model toys as described. Ensure correct sizing and thread compatibility with your specific model before installation.