New PWM 1600W 20A Hall Motor Control Driver Board Motor Regulator DC 6-80V BLDC Three Phase DC Brushless Motor Controller

New PWM 1600W 20A Hall Motor Control Driver Board Motor Regulator DC 6-80V BLDC Three Phase DC Brushless Motor Controller This product is a drive module developed for inductive BLDC motor. The drive master chip is SNR8503M, and the special circuit for inductive motor drive is integrated inside the chip, supporting the Hall electric Angle of 120 degrees or 60 degrees, and the default is 120 degrees. It has simple peripheral circuit, complete functions, small size, simple debugging, high driving efficiency, and flexible application. Wide application and other characteristics. SNR8503M is a 32-bit core MCU, which is very convenient for development and simulation debugging. In order to facilitate users to quickly drive the inductive BLDC motor, our company has completed the core algorithm of the software, and users only need to carry out secondary development on the basis of this software to quickly complete product development. The length and width of the drive module is 78x57mm, the thickness of the plate is 1.6mm, the working voltage is 6-80V, and the anti-reverse connection protection is supported, and the module will not be damaged due to the power line reverse connection. The module is bare by default. If the motor is driven below 5A current, it does not need to be forced to dissipate heat, but only needs to ensure normal ventilation. If the drive current exceeds 5A, it must be forced to dissipate heat. Board 5pin Hall interface, used to access the motor Hall signal. Onboard LED indicator for standby, working, error and other states. Onboard potentiometer (0.5~5V),PWM speed control interface (frequency 1~20KHz), duty cycle 10~100%. Onboard FG speed feedback interface, calculation speed RPM=FG frequency Hz*60/pole number. Onboard CW/CCW steering interface, suspended for clockwise CW, short-circuited GND for counterclockwise CCW steering. Onboard UART serial port. Users can control the module through the serial port protocol. Onboard burning interface for updating the burning program. Operating voltage: 6-80V Maximum current: rated 20A peak 50A(a fan must be added to dissipate heat) Maximum power: 1600W Overcurrent protection: yes Product size: 78mmx57mmx20mm Motor drive base There is hall starting and commutating bottom layer Phase compensation algorithm Velocity closed-loop PID algorithm Current limiting PID algorithm Downwind start-up algorithm Pumps, medical equipment, all kinds of compressors, all kinds of fans/fans, electric screwdrivers, electric curtains, automatic doors, hydraulic oil pumps, air pumps, refrigerators brushless DC compressors, lawn mowers, sprayer, underwater thrusters, etc. 1. Due to the light and screen difference, the item's color may be slightly different from the pictures. 2. Please allow 1-3cm differences due to manual measurement. Package Included: 1x DC Brushless Motor Controller