Solar Drip Irrigation System with Timer for Potted Plants, Automatic Watering Kit with Solar and USB Charging

Solar Automatic Drip Irrigation Kit Overview A selfcontained automatic drip irrigation kit with a programmable timer, builtin rechargeable battery, and solar charging. Designed to deliver precise amounts of water directly to plant roots, the system reduces manual watering and adapts to a variety of small and mediumscale gardening needs. Key benefits Automatic timer: Set watering schedules on the smart controller so plants are watered at preset times without daily manual attention. Solar plus USB TypeC charging: Builtin 3.7V 3600mAh battery is charged by the included solar controller or by USB TypeC, providing flexible power options. Precise water delivery: Adjustable drip heads and a calibrated drip system deliver measured amounts of water to each plant, reducing overwatering and water waste. No external water pressure required: The builtin pump operates independently of household water pressure, allowing use where pressurized water is not available. Easy to install: Designed for straightforward assembly with minimal tools required and clear instructions, suitable for beginners. Features and performance Item type: Solar Automatic Drip Irrigation Kit Smart controller size: approximately 13 x 11 cm (5.12 x 4.33 in) Rated voltage: DC 3.7 V Battery: 3.7 V 3600 mAh, builtin and installed Charging mode: Dual charging, solar and USB TypeC Maximum pressure: 30 psi Suction capability: 1.5 m or greater Maximum flow rate: 0.7 L per minute Hose length: approximately 15 m (49.21 ft) Operating temperature: 4 to 45 C (39.2 to 113 F) Noise at 30 cm: 65 dBA or lower Weight: approximately 894 g (31.53 oz) What is included 1 x Smart Controller 2 x Ground Insert Bracket 1 x Hose 1 x Pipe Cutter 2 x Expansion Screws 2 x Screws 1 x Anti Siphon Valve 1 x Connection Cable 1 x Filter 2 x Inlet/Outlet Water Port Clamp 15 x Tee Joint 15 x Adjustable Drip Head (or 15 x Drip, depending on kit variant) 1 x Instruction Manual Practical use scenarios Balcony or patio potted plants: Install the hose and adjustable drip heads to ensure consistent watering for herb pots and container plants while you are away. Small greenhouse or seed starting bench: Provide controlled, lowvolume irrigation to seedlings and young plants without overwatering. Vegetable rows and flower beds: Lay the 15 m hose and tee joints to create a drip grid that delivers water directly to root zones across a small garden area. Installation and operation Basic assembly requires minimal tools. Use the included pipe cutter and mounting brackets to lay out the hose and position the drip heads. Install the anti siphon valve and filter between the water source and the controller to protect the pump and maintain clean flow. Place the solar controller where it receives adequate sunlight for solar charging, or connect a USB TypeC power source for charging. Set the timer on the smart controller according to your plants watering schedule. Refer to the instruction manual for detailed setup instructions and timer programming. Why this kit solves common problems Eliminates the need for daily manual watering by automating schedules. Provides consistent, measured watering to reduce plant stress from under or overwatering. Operates independently of household water pressure thanks to the builtin pump. Offers flexible charging options so the system continues to run even in low sunlight conditions when USB charging is available. Compatibility and applicability Suitable for potted plants, balcony gardens, greenhouses, vegetable gardens, lawns, and flower beds. Hose length and adjustable drip heads allow for layouts up to approximately 15 m. Notes Follow the included instruction manual for correct installation and timer programming. The kit is with the builtin 3.7 V 3600 mAh battery installed.