Digital Angle Finder with Magnetic Base, AutoRotating LCD Backlight Display, Aluminium Alloy Level

Key benefits Clear numeric readout that is easy to read in most conditions, reducing guesswork and rechecks. Automatic display orientation and magnetic attachment make singleperson, hands measurements simpler and more stable. Fast unit switching supports different trade conventions and measurement needs without manual conversion. Main features LCD digital display with backlight: long press the H L key to turn on the backlight. The backlight automatically turns off after 30 seconds to conserve battery. The display shows readings clearly for quick interpretation. Autorotating display: the display automatically flips through four 90 degree orientations so readings remain upright when the tool is inverted or rotated. Singlesided magnet: a magnet on the measuring surface attaches to metal surfaces for stable, hands placement during measurement. Unit selection: press the M B key briefly to cycle between measurement modes: degrees, percent (slope), mm/m, and IN FT (decimal fraction). Unit changes occur in sequence for quick conversion. How this solves common problems Eliminates orientation confusion by autoflipping the display when the level is turned, so you always read the measurement upright. Reduces the need for a second person to hold the tool in place because the magnet secures the level to metal surfaces. Speeds up workflow by letting you switch units instantly on the device, avoiding time spent converting values manually. Performance and compatibility Provides numeric digital readings on an LCD screen with backlight for improved visibility. Attaches to ferrous metal surfaces via a singlesided magnet for steady measurements on metal frames, pipes, and beams. Supports four unit formats to match industry and regional measurement preferences. Practical use scenarios Installing metal shelving or conduit: attach the level to a steel shelf bracket or conduit run and confirm true horizontal or vertical alignment with the magnet holding the tool in place. Carpentry and trim work where angle and slope matter: cycle to degrees or IN FT decimal fraction to transfer or verify angles and ensure precise cuts. Plumbing and HVAC installations: use the percent slope or mm/m modes to check fall and drainage or verify pitch on piping and duct runs. Operation tips To use the backlight, long press H L; it will autoturnoff after 30 seconds to save power. To change units, press M B briefly and step through degrees, percent, mm/m, and IN FT decimal fraction. Rotate or invert the level as needed; the display will automatically flip so the reading remains upright. This digital level provides clear digital readings, automatic display orientation, and magnetic hands mounting to help professionals and DIY users achieve accurate, repeatable measurements across a variety of tasks.