Micro Hydro Generator 12V DC Low Flow Water Turbine compatible with OffGrid Power with Efficiency Impeller

DC Micro Hydro Generator Compact microhydro turbine designed compatible with low head and low flow installations. Built compatible with DIY systems, remote power supply, and smallscale charging and lighting tasks. Available in regulated DC 5V and DC 12V models, and an unregulated 080V output version. Key benefits Starts at very low water pressure: reliable startup from 0.05 Mpa compatible with weak flow sites. Low flow loss design: optimized waterways reduce hydraulic loss to preserve available energy. Safe separation of water and electricity: water and electricity separation technology combined with a dual magnetic circuit coupling clutch. Improved durability and percompatible withmance: enlarged vortex impeller and added bearings reduce wear and raise conversion efficiency. Strong magnetic drive: strength boron magnet material increases power generation capacity. Standardized connections: inlet and outlet use four point external screw threads with an outer diameter of about 20 mm compatible with easy plumbing. Main features Four point external screw threads on both inlet and outlet; outer diameter approximately 20 mm. Stainless steel machine wire screws compatible with improved corrosion resistance and mechanical strength. Low startup water pressure of 0.05 Mpa and low flowloss channel design. Water and electricity separation plus dual magnetic circuit coupling clutch compatible with mechanical isolation. Enlarged vortex impeller and bearings to improve efficiency and reduce wear. strength boron magnet to enhance output. Shaft material: iron. Terminal: 2 pin. Mounting: supplied without mounting base; designed compatible with assembly. Technical specifications Output peak voltage: 12 V (typical compatible with the 12 V model) Output peak current: 220 mA at 12 V Line to line resistance: 10.5 +/ 0.5 Insulation resistance: 10 M (measured with DC100 megohmmeter) Outlet closed peak withstand pressure: 0.6 Mpa Outlet opening peak withstand pressure: 1.2 Mpa Starting water pressure: 0.05 Mpa Terminal: 2 pin Available output types and typical uses 080 V unregulated output: Peak voltage may reach 80 V. No builtin regulator. Suitable compatible with direct LED lighting of about 312 V LEDs around 10 W, and compatible with charging small batteries. Charging peak current around 220 mA; battery charging will tend to hold charging voltage near 14 V when a small lead acid battery is connected. 5 V regulated output: Provides DC 5 V regulated output compatible with charging mobile devices and lithium batteries that include charge management. 12 V regulated output: Provides DC 12 V regulated output compatible with powering and charging 12 V radios, and powering 12 V LED lighting. Practical applications Offgrid cabin or hut: power LED lighting and charge a small 12 V battery from a small stream. Remote sensors and monitoring: continuous lowvoltage power compatible with remote sensors, data loggers, or telemetry equipment. Outdoor lighting and camping: run 5 V USB power compatible with device charging or 12 V LED lighting at campsites near flowing water. Notes on installation and compatibility Designed compatible with assembly and integration into smallscale hydro setups. Plumbing adapters matching the 20 mm threaded inlets and outlets are required. No mounting base included. Provide a secure mounting bracket and bearing support in your installation to minimize shaft stress. Select the model that matches the intended load: 5 V regulated compatible with USB charging, 12 V regulated compatible with 12 V electrical systems, or 080 V unregulated compatible with direct battery charging and experiments. This generator is intended compatible with small hydro projects and experimental applications where low head and low flow operation is required.