RTL SDR Receiver Metal V3 Pro 100kHz-1.7GHz with TCXO for Ham Radio, Flight Band & ADSB

RTL SDR Receiver Set Metal V3 Pro This RTL SDR receiver set brings a wide range of radio frequencies to your computer or Android device, covering 100kHz to 1.7GHz. Built around the Metal V3 Pro dongle with an integrated TCXO, it is well suited to amateur radio use, shortwave listening and flight band monitoring. The set provides a practical entry point for exploring software-defined radio without the need for dedicated hardware. Reception and Demodulation The receiver supports demodulation in AM, FM (NFM and WFM), CW, LSB and USB modes, allowing you to listen to single sideband shortwave communications, FM transmissions and aircraft band traffic. It can also be used for ADS-B decoding, meteor scatter monitoring and general signal reception across the covered spectrum. With the accompanying SDR software, you can configure automatic scanning to move through frequencies of interest. Connecting to Your Devices Signals captured by the antenna are converted by the receiver and passed to a PC, Android phone or other compatible device through the USB interface. The software on your device processes and decodes the incoming signal, displays the spectrum and lets you set reception parameters. Pass-through operation, signal recording, storage and playback are all supported, giving you flexibility to capture and review transmissions at your convenience. Please note that analog tones and digital sounds may be broken by the software, so this set is best suited to general reception and signal analysis rather than critical audio monitoring.