Non-slip adhesive tape with luminous film glows in the dark, safety tape for stairs, ladders, slippery floors indoors 10 m 5 cm

28.95 CHF
+ 10.99 CHF Livraison

Non-slip adhesive tape with luminous film glows in the dark, safety tape for stairs, ladders, slippery floors indoors 10 m 5 cm

Vendu par:

28.95 CHF

Économisez 35.05 CHF (54%)

Prix de vente recommandé

64.00 CHF
En stock
+ 10.99 CHF Livraison

Retours sous 14 jours

Modes de paiement:

  • Marque: Unbranded

Détails du produit

Détails du produit

Non-slip adhesive tape with luminous film glows in the dark, safety tape for stairs, ladders, slippery floors indoors 10 m 5 cm

LIGHT REMINDER: Tape with green fluorescent film will glow in the dark So you can ;use to highlight stairs and easier to see to avoid tripping on the last step at night.ADD GRIP TO PREVENT SLIDING: The tape is made from 80-grit aluminum oxide which creates superior, durable traction on the slippery area. So you don;t have to worry about slipping and you will feel safer going up or down the stairs.DURABLE ADHESIVE AND RESIDUE FREE: quality glue resists cracking and peeling. At the same time, when you need to replace or reposition, it will not leave any residue or damage your flooring.SUITABLE FOR REACH: suitable for highlighting stair nosings and dangerous steps. Such as loading dock edges, basement stairs, movie theater stairs, bunk bed ladders, garage and any other potentially hazardous areas.APPLY & Dimensions: simple to install and use, just peel the stick and roll out the bubbles; Dimensions: 50mm wide x 10m long, Luminous.SpecificationMain Construction material: gravel, paper, strong glue, fluorescen>Applicable temperature: 14-140? / -10-60 ?Designed for: flat, clean, smooth, hard floors or surfaces (e.g. floors, stairs, steps, hallways, ramps, vehicle steps, emergency exit ladders, scaffolding, cinema aisles, etc.)Not Designed for: rough, soft, damp, dusty or porous groundHOW TO USE?1. Make sure contact surfaces are flat, clean and dry when you apply.2. Cut the ribbon to the desired length and round the corners with scissors.3. Peel the release paper and place it in the desired location. (When the temperature is low, heat slowly with a hair dryer and buff with good results).4. Pressure is applied evenly from the center of the strip to both ends. (The applied tape waited 24 hours)5. Place the tape on a light source for a while to glow in the dark.TipsThe tape absorbs 15-20 minutes . The light source may remain light for a while. (The more light is absorbed, the lighter and more durable the light, and then slowly weakened)Please note: The data is all measured manually, please allow 1-3cm error, due to the difference in light and display, there will be a certain color difference, the actual object received shall prevail.
  • Identifiant Fruugo: 556421643-1124257747
  • EAN: 5756870375841
Sécurité

Informations sur la sécurité des produits

Veuillez consulter les informations de sécurité du produit spécifiques à ce produit décrites ci-dessous.

Les informations suivantes sont fournies par le détaillant tiers indépendant vendant ce produit.

Étiquettes de sécurité des produits

CE Mark
Avertissements de sécurité: Please do not let children use the product alone.

Livraison

Livraison

Expédition dans un délai de 3 jours

  • STANDARD: 10.99 CHF - Livraison entre jeu. 26 novembre 2026–jeu. 03 décembre 2026

Expédié depuis le Chine.

Retours

Retours

Nous mettons tout en œuvre pour que les produits que vous commandez vous soient livrés dans leur intégralité et conformément à votre commande. Néanmoins, si vous recevez une commande incomplète, des articles différents de ceux commandés ou si, pour toute autre raison, la commande ne vous satisfait pas, vous pouvez retourner la commande ou tout produit inclus dans celle-ci et obtenir le remboursement intégral des articles retournés.

Consulter la politique de retour complète